Icom ID-800H

90
11
DIGITAL MODE OPERATION
11
■ Low-speed data communica-
tion
In addition to the digital voice communication, a low-speed
data communication is available.
qTurns OFF the transceiver
wWhile pushing [SET•LOCK], push and hold [PWR] for
1 sec. to enter initial set mode.
(see p. 104)
ePush [SET•LOCK] or [S.MW•MW] several times to select
the data communication speed setting.
(see p. 110)
•“SPD” appears.
• Rotate [DIAL] to select suitable data speed for your PC or appli-
cation.
rPush [PWR] to exit initial set mode, then set the desired
frequency.
tSet repeater call signs, transmit output power and other
conditions.
yPush [SET•LOCK] to enter set mode.
• Rotate [DIAL] to select “SET,” if “CALLS” or “MESSAG” is dis-
played.
uPush [SET•LOCK] or [S.MW•MW] several times to select
the automatic data transmission setting.
(see p. 99)
•“DVT” appears.
• Skip this setting, if you want to transmit manually.
iStart up the low-speed data communication application.
oSet the application as follows.
• Port : The same COM port number as ID-800H’s
• Baud rate : 4800 bps or 9600 bps (same as step e)
• Data : 8 bit
• Parity : None
• Stop : 1 bit
• Flow control : Xon/Xoff
!0Transceiver automatically transmits or receives the data
while the computer is sending data to transceiver. Or push
and hold [PTT] to transmit, release to receive the data
manually.
• Refer to the instructions of the application that how to send or re-
ceive data.
ID-800H Personal computer
to [DATA] socket
to RS-232 port
OPC-1384
[DATA]
socket
Rear view
ID-800H_1.qxd 2007.06.14 3:09 PM Page 90