Icom ID-800H

IV
QUICK REFERENCE GUIDE
D Optional MB-58 installation
The optional MB-58 REMOTE CONTROLLER BRACKET is avail-
able for separate installation.
qDrill 2 or 4 holes where the bracket is to be installed.
• Approx. 4 mm (
1
⁄8″) when using nuts; approx. 1–2 mm (
1
⁄16″)
when using self-tapping screws.
wInsert the supplied screws, bolts and washers through the
mounting base and tighten.
eAdjust the angle for the clearest view of the function dis-
play and tighten 2 screws when the mounting base is used.
rAttach the supplied Velcro pads (large) to the remote con-
troller and bracket.
tAttach the supplied Velcro pads (small) or rubber pad to
the bracket as shown below; then attach the remote con-
troller.
• When using the optional MB-65
MB-58
MB-65
Adjust the viewing angle
for maximum visibility of
the function display.
MB-58 ID-800H remote controller
Bracket
When using self-
tapping screws.
Mounting
base
Mounting
bolt
Quick reference guide
ID-800H_1.qxd 2007.06.14 3:08 PM Page IV