Icom ID-800H

78
11
DIGITAL MODE OPERATION
11
DD
Received station call sign indication
➥ Push and hold [TONE•T-SCAN•BK], until 2 beeps sound,
to display the received station call sign.
• The first 6-digit of the stored call sign in “RXCALL” are displayed.
• While continuing to hold [TONE•T-SCAN•BK] even if 2 beeps
sound, a long beep will sound and the stored call signs (in “RX-
CALL,” “RXRPT1” and “RXRPT2”) are set for operation (see
“One-touch reply using the call record” as below). While continu-
ing to hold [TONE•T-SCAN•BK] even if a long beep sounds, a
long beep will sound again and the break-in function will be set
(see p. 84)
• When a call sign has not been received correctly, “NoCALL” is
displayed.
DD
One-touch reply using the call record
The stored call signs in the call record can be set for opera-
tion to reply to the call.
q After receiving a call, push and hold [TONE•T-SCAN•BK]
until 2 regular and 1 long beeps sound.
Or, during the received call sign indication as described in
“Desired call record indication” at left, push [SET•LOCK]
for 1 sec.
• Set your own call sign (MyCALL) in advance.
• The call sign stored in “RXCALL” is set to “UrCALL,” “RXRPT1”
is set to “RPT2 C” and “RXRPT2” is set to “RPT1 C.”
w Push [PTT] to transmit; release to receive.
to select “r15”
Push
Push
to select “r20”
Push then for 1 sec.
Push for 1 sec.
• Example— Copying the call sign memory “r15”
into “r20”
ID-800H_1.qxd 2007.06.14 3:09 PM Page 78