Icom ID-800H

80
11
DIGITAL MODE OPERATION
11
“MyCALL,” “UrCALL,” “RPT1 C” or “RPT2 C” as desired.
e Push [BAND•MODE] then rotate [DIAL] to select the de-
sired call sign channel to be copied.
• M01 to M06, U01 to U99 and r01 to r54 are available.
r Push [SET•LOCK] for 1 sec. to set the selected call sign
for operation.
t Rotate [DIAL] to select the desired call sign channel to
copy to.
y Push [S.MW•MW] for 1 sec. to copy the selected call sign
into the selected call sign memory.
u Modify the copied call sign as described in “Call sign pro-
gramming”
(pgs. 61–64) or “Repeater call sign program-
ming”
(pgs. 69, 70).
z During VFO mode, push [
SET B(D-OFF)] to enter
call sign set mode.
• Push [
YY
]/[
ZZ
] to select “CALL” if necessary.
x Push [ SET B(D-OFF)] or [ ENT C(T-OFF)] several
times to select “MyCALL,” “UrCALL,” “RPT1 C” or
“RPT2 C” as desired.
c Push [BAND] then push
[
YY
]/[
ZZ
] to select the de-
sired call sign channel to be copied.
• M01 to M06, U01 to U99 and r01 to r54 are available.
v Push [ SET B(D-OFF)] for 1 sec. to set the se-
lected call sign for operation.
b Push
[
YY
]/[
ZZ
] to select the desired call sign chan-
nel to copy to.
n Push [FUNC], then push and hold [
CLR A(MW)]
for 1 sec. to copy the selected call sign into the
selected call sign memory.
m Modify the copied call sign as described in “Call
sign programming”
(pgs. 61–64) or “Repeater call
sign programming”
(pgs. 69, 70).
SET
B
ID-800H_1.qxd 2007.06.14 3:09 PM Page 80