Icom IP503H - Searching Network Operator

3
ADVANCED OPERATION
3-14
1. Setting the Network Search function enable
1. While holding down [FUNC], turn ON the power.
• Enter the Set mode.
2. Release [FUNC] when “SET” is displayed.
3. Push [FUNC] or [Address] several times to select “Network
Selection.”
4. Push [▲]/[▼] to select “User Select.”
5. Push [CLR/LOCK].
• Exits the Set mode.
2. Starting a Network Search
1. Push [FUNC] several times to select “Network Search.”
2. Push [Call history] to start a search.
• Network search starts.
• The search result will be displayed in few minutes.
L Search may take a time, depending on the environment.
LIf “Timeout” is displayed, try a different location.
3. Push [▲]/[▼] to select an operator.
• Select “Search” if you start the search again.
4. Push [Call history] to set the selected operator.
• “Congured” is displayed.
■ Searching network operator
The Network Search function search the available operator.
– – –
LOG
SET
– – –
LOG
SET
[FUNC]
[CLR/LOCK]
[▲]/[▼]
(Example)
User select
Network Selection
SET
[FUNC]
[▲]/[▼]
[Call history]
Search
Network Search
ABCD
12345
Network Search
Configured
Network Search
[Address]
NOTE:
• This function may not work, depending on the country of use or service provider setting.
• The transceiver may not connect to the operator in the search result, depending on the communication service contract.
(For example: Roaming is not supported.)