Icom IP503H - Initializing Bluetooth Pairing Lists

5
OPTIONAL PRODUCTS
5-22
1. While hold down [FUNC] and [Address], turn ON the power.
• Enters the Set mode.
2. Release [FUNC] and [Address] when “SET” is displayed.
3. Push [FUNC] several times to select “Initialize Bluetooth Unit.”
4. Push [▲]/[▼] to select “YES.”
• To cancel the initialization, push any key other than [Call history].
5. Push [Call history].
• The pairing list is initialized and the transceiver automatically restarts.
■ Initializing the pairing list of the IP501H/IP503H
If you have some troubles with the Bluetooth operation, initialize the pairing list, as shown below.
LAll the paired Bluetooth devices are deleted from the pairing list by the initialization.
LThe pairing list is not initialized by the “RESET” item in the Set mode.
– – –
LOG
SET
YES
Init BT Unit
SET
[電源/音量]ツマミ
[FUNC]キー
[▲]/[▼]
キー
[履歴]
キー
[ アドレ ス 帳 ]
キー
[PWR/VOL]
[FUNC]
[Call history]
[Address]
[▲]/[▼]