48
10.5 Change the Recall Time
You may need to press (ECLIPSE Handset) to send a Flash signal
(also called Recall or Timed Break Recall) if you are connected to a PBX or
using certain network services. You should normally leave the Recall
Time at its default setting, Short (100ms), as this is the standard recall
required in the UK telephone network. However, it can be changed to
Medium (270ms) or Long (600ms) if your telephone is connected to a
PBX that requires a different recall time.
- On Your ECLIPSE Handset
1. From the home screen, press .
2. Press / to SETTINGS and then press to select.
3. Press / to RECALL TIME and then press to
select.
4. Press / to select SHORT, MEDIUM or LONG and
then press
to confirm.
• A confirmation tone is played.
5. Press
to return to standby mode.
To Next Page
Loading...
