26 iDirect Satellite Router Installation and Commissioning Guide
iDX Release 3.3
Loading Packages with iSite
When loading of the board support package is complete, perform the remaining steps in this
section to load the remote image package on the Satellite Router.
To Load the Remote Image Package:
1. Click the Op
en button in the Download Package dialog box again, and navigate back to
the remote packages on your laptop.
2. Double-click the applicable rem
ote image package in the Open dialog box. The file has a
.pkg file extension.
Note: In folders containing files for more than one model, be
sure to select the
remote package applicable to the connected Satellite Router.
3. In the Down
load Package dialog box, select the following options, as before:
• Don’t check versions
• Download images only
• Don’t reset
4. Click the St
art button.
5. Wait while the file transfer progresses. Observe the Inf
ormation section of the Download
Package dialog box until the word Done is displayed.
After loading both software
packages on the Satellite Router, continue to “Loading Options
Files with iSite” on page27.
To Next Page
Loading...
