IDTECH Kiosk V - Kiosk V Low-Level Commands; Activate Transaction Command (02-40)

ID TECH Kiosk V User Manual
Page | 22
10. Kiosk V Low-Level Commands
The following are commonly used commands for the Kiosk V. For a full list of available commands,
contact your ID TECH representative for the NEO 2 Interface Developer’s Guide.
10.1. Activate Transaction Command (02-40)
The Activate Transaction command begins a contactless EMV or contactless MagStripe Card
transaction.
Note: While an Activate command is in progress, readers only accepts a Cancel or Stop command.
Do not send other commands until Activate Transaction has completed, because the reader will
interpret these as a Cancel Transaction command.
Command Frame
Byte 0-9 Byte 10 Byte 11 Byte 12 Byte 13
Byte 14 …
Byte 14+n-1
Byte 14+n Byte 15+n
Header Tag
& Protocol
Version
Command
Sub-
Command
Data
Length
(MSB)
Data
Length
(LSB)
Data CRC (LSB) CRC (MSB)
ViVOtech2\0 02h 40h
See Data
Format below
Activate Transaction Command Frame Data Format
Data Item
Length (bytes)
Description
Timeout
1
Time in seconds that the reader waits for a card to be presented
before timing out and returning an Error response. The reader will
continue to poll for this amount of time if no card is found.
Note that if a card is found, the transaction may not complete
within the timeout period.
This field must be present in the Activate command.
Format: Binary
TLV Data
varies
See Activate Command TLVs in the NEO IDG.