p.69F7 SETUP MENU
l appear with a beep sound when you present a card.
●
ID
Refers to a Personal Identification Number (PIN) that consists of 4-8 digits. Enter a 4-8 di
git ID number (PIN) and press <ENT> key. (An ID number of the LX007SR consists of 4-1
0 digits.)
●
PW
stands for a password that is required for verification in the ID + Password operating mo
de.
●
TA
Refers to the Time Schedule code (‘00’ - ‘10’) for the Reader*1 (i.e. the built-in reader). I
f you assign a Time Schedule in this field, the new cardholder can gain access only durin
g the assigned Time Intervals. To set the Time Intervals for each Time Schedule code, ref
er to the instructions on the Time Schedule Setup in the [F4 SETUP MENU]. If you wish t
o give the cardholder unlimited access time, enter the default Time Schedule code '00' f
or the value.
●
TB
Refers to the Time Schedule code (‘00’ - ‘10’) for the Reader*2 (i.e. the exit reader). If yo
u assign a Time Schedule in this field, the new cardholder can gain access only during th
e assigned Time Intervals. To set the Time Intervals for each Time Schedule code, refer to
the instructions on the Time Schedule Setup in the [F4 SETUP MENU]. If you wish to giv
e the cardholder unlimited access time, enter the default Time Schedule code '00' for th
e value.
●
RD
Refers to the Reader Assignment code for the cardholder. Entering the code ‘0’ and '3' a
ssigns both readers (Built-in Reader and Exit Reader) to grant access to the cardholder t
hat is being registered, code ‘1’ only assigns Reader*1 (Built-in Reader) and code ‘2’ assi
gns Reader*2 (Exit Reader). If you enter ‘1’ in the RD field(Only Reader*1 assigned) and
try to exit through Reader*2 (Exit Reader) then the LX007 generates an error message
(“Access Door Error”) on the LCD display.
●
C
Refers to the ID code. Code ‘0’ is default and codes ‘1’ and ‘2’ are codes are used for the
TWO MEN MODE. Code ‘3’ is used for the ARM/DISARM function and code ‘4’ is assigne
d for lost cards.
●
MA
Refers to the Operating Mode that the new cardholder will use on Reader*1 (i.e. the bu
ilt-in reader). If you enter ‘1’ for MA, for example, this card holder will be able to gain ac
cess using his or her ID only.
○
‘0’ – Depend on System Operating Mode ([F1 SETUP MENU] > [READER*1 MODE])
○
‘1’ – ID Only Mode
○
‘2’ – ID + Fingerprint (Password)
To Next Page
