IDTECK LX007 - The Device Works with RF Cards While It Does Not Work with Keypad; Please Check if the Keypad Is Set to NOT USE; Buzzer Keeps Making Sounds. Bee~ Bee~ Bee; Please Check if the Door Is Closed Well

p.91A buzzer keeps making sounds. "Bee~~~~~"
5 The device works with RF Cards while it does not wor
k with keypad.
5.1 Please check if the keypad is set to "NOT USE".
The default for the keypad input is "NOT USE".
1. See [12 Setting Changes] > [1 F1 SETUP MENU] > [1.5 Reader #1 KEY Input] and set it
to "USE".
If the problem persists, please contact service center.
6 A buzzer keeps making sounds. "Bee~ Bee~ Bee~"
6.1 Please check if the door is closed well.
If a door remains open longer than the preset time, "Door open alarm" goes off. Close the d
oor.
If the problem persists, please contact service center.
7 A buzzer keeps making sounds. "Bee~~~~~"
7.1 Check if the tamper switch is pressed well.
●
The device has a tamper switch on the back to check if the device is fixed on the wall we
ll.
●
The tamper switch should be being pressed when and after the installation. If the switch
is not pressed, tamper alarm is activated and the buzzer sounds an alarm.