GB
6 - USE AND OPERATION MASTER 880MP E-volution
6 - Pag. 12 / 17
6.7 AUTOMATIC CYCLE START
• Power the lathe on.
• Turn the main power switch to the position I (ON).
• Press
to start the bar feeder.
• Press
to select the manual mode.
• Carry out a “BAR FEEDER ZERO SETTING” in the following way:
-press the start buttons plus
;
INFORMATION:
Axes zero setting can be performed with the guides open or closed.
• Load one bar in the guides and start the automatic cycle. (See section 6.8.).
To Next Page
Loading...
