25
UK
7 Set-up
7.1 Interfaces and system requirements
The users are responsible for the safe function of the application programs
which they created themselves� If necessary, they must additionally carry
out an approval by corresponding supervisory and test organisations
according to the national regulations�
The programmer creates the application program with the IEC 61131-3 compliant
CODESYS programming system and loads the applications via the Ethernet,
RS-232 or CAN interface to the controller� For the required information about
installation and set-up, see the programming manual�
Required components:
• suitable CODESYS version
• CODESYS plug-ins
• CODESYS package for the controller
• firmware (note: check firmware version!)
• release notes
To program the controller, the people should be familiar with the CODESYS
software and the CODESYS Safety SIL2 extension�
The people should also have knowledge of the following topics:
• requirements on safety-related programming
• required user-specific standards
7.2 Required documentation
In addition to the CODESYS programming system, the following documents are
required for programming and set-up of the device:
• CODESYS V3�5 programming manual
The manuals can be downloaded from the internet:www�ifm�com
CODESYS online help:
www�ifm�com (in the download space with registration)
To Next Page
Loading...
