9
UK
5 Installation
5.1 Installation location
The following installation locations are permitted:
• inside of the cabin
• body
• vehicle frame
Installation on the motor/engine is not permitted�
For non-mobile applications, the applicable directives are to be adhered to, taking
into account the specified environmental conditions�
5.2 Mounting surface
The housing must not be exposed to any torsional forces or mechanical
stress�
► Use suitable compensating elements if there is no flat mounting surface
available�
Mounting surface
► During installation, ensure that the pollution degree is 2 or better� Pollution
degree 2 is a light, common contamination which can become conductive
caused by occasional condensation or hand perspiration (DIN EN 60664-1)�
To Next Page
Loading...
