Ihse Draco U-Switch - Switching Via Multi-Screen Control

Draco U-Switch Operation
43
7.2 Switching via Multi-Screen Control
When using sources in multi
-head operation (e.g., Dual-Head), the switching is only working manually via
keyboard commands. Any non
-observance may have a negative influence on the stability of the system.
The function cannot be guaranteed when using wireless keyboards and mice.
When moving the mouse cursor over the edge of a display, you can switch from your console to displays
located horizontally or vertically. Therefore, the respective mode has to be activated before.
Mode
Activate/deactivate
switching via mouse
Keyboard command
Mode 0 Deactivate switching
via mouse
Hot Key, o, x, 0, Enter
Mode 1 Activate horizontal
mode
Hot Key, o, x, 1, Enter
Mode 2 Activate vertical mode
Hot Key, o, x, 2, Enter
Mode 3 Activate block mode
Hot Key, o, x, 3, Enter
Mode 4* Activate free mode
Hot Key, o, x, 4, Enter
* Mode 4 can only be activated via keyboard commands if this mode have been configured via
management software during initial installation or after a factory reset.
When switching via mouse is deactivated (mode 0), only switching via keyboard
sequences is possible
(see
chapter
7.1, page 42).
Additional software for calibrati
ng and positioning of the mouse pointer is not necessary.