Ihse Draco U-Switch - Resetting the U-Switch to the Factory Settings

Draco U-Switch
55
9.3 Resetting the U-Switch to the Factory Settings
NOTICE
If a firmware update has been carried out since the delivery, this firmware version is retained.
To reset the U-Switch back to default settings, proceed as follows:
1. Connect the U-Switch to any source using a Mini-USB cable.
The U-Switch opens a flash drive containing the Config.txt file.
2. Delete the Config.txt file.
3. Manually power off the U-Switch.
4. Power on the U-Switch.
The U-Switch restarts.