English
22
WARNING: If you cannot complete the pro-
the “ON/OFF” button and start the procedure
again from the beginning (STEP 1).
Information on resin regeneration with salt
The regeneration phase is carried out at the end of a
washing cycle.
Approximately 3.5 litres of water are consumed in the
resin phase, with an energy consumption of approxi-
mately 1Wh and an increase in cycle time of approxi-
mately 7 minutes.
Rinse aid
-
ner, the display will indicate the lack of rinse aid.
majority of users.
Adjusting the amount of rinse aid
ALWAYS start the procedure with the
• Switch the appliance on, press “ON/OFF”
button.
For the Eco cycle, it is as shown in the table.
Level Display Frequency
S0 DISPLAY S0 Never
S1 DISPLAY S1 1 every
9 cycles
S2 DISPLAY S2 1 every
7 cycles
S3 DISPLAY S3 1 every
5 cycles
S4 DISPLAY S4 1 every
4 cycles
S5 DISPLAY S5 1 every
3 cycles
S6 DISPLAY S6 1 every
2 cycles
S7 DISPLAY S7 Every cycle
• Hold the “setup 5 sec” button, a short beep will
sound
• The “SETTINGS” message appears on the
display.
• Press the “PROGRAMME SELECTION” but-
• Choose the “RINSE AID” option. Press “START/
RESET” to access the regulation levels.
• Press “START/OK” to access the regulation
levels.
• Press “PROGRAMME SELECTION” to choose
the value (R1......R6). With level R0, no rinse aid is
dispensed. (see table)
• Press “START/OK”
• Press “ON/OFF”
Rinse aid level
(multi dosage)
Meaning
0
No multi dosage and
rinse aid detection.
1 1 pulse (1 doses)
2 2 pulse (2 doses)
3 3 pulse (3 doses)
4 4 pulse (4 doses)
5 5 pulse (5 doses)
6 6 pulse (6 doses)
The limestone content of the water considerably
performance.
It is therefore important to regulate the quantity of
rinse aid to achieve good washing results.
If, after the wash, there are streaks on the dishes,
decrease the amount by one position. If whitish spots
occur, increase the amount by one position.
To Next Page
Loading...
