English
21
Changing the programme does not change the
delay time and the LED will remain on.
When you press the DELAY START button, the last
setting made will be displayed.
Countdown and Programme start with DELAY
START
• When the delay is set on a programme: after
pressing “START/OK”.
• The “DELAY START” light stays on until the end
of the time.
• The delayed time countdown starts showing on
the display “START IN XX: XX”.
• The time will be displayed with 30-minute inter-
vals over 24 hours and one-minute intervals over
the last 2 hours.
• Pressing any button (except the “ON/ OFF,
START/OK” buttons for 3 seconds, the pro-
gramme name “P XX” is displayed (P + pro-
gramme number) for one single scroll and then
the delay time is displayed again.
In the event of a power failure or shutdown,
the dishwasher stores the time remaining at
the start, which will be resumed at the point
where it was interrupted once the power
supply is restored or the machine is switched
on again.
If you want to cancel the delayed start proceed
as follows:
• Press and hold the “START/OK” button for at
least 3 seconds. The display will show “RESET”
and beeps will sound.
• The delayed start and the selected programme
will be cancelled. Two dashes will appear on the
display.
• At this point, if you want to start the dishwash-
er, you will need to set the desired programme
again and select the option buttons if necessary.
Depending on the source of the supply, water contains
varying amounts of limestone and minerals which are
deposited on the dishes leaving whitish stains and
marks. The higher the level of these minerals present
in the water, the harder the water is.
which, through the use of special regenerating salt,
supplies softened water for washing the dishes. The
degree of hardness of your water can be obtained
from your water supply company.
Regulating the water softener
The water softener can treat water with a hardness le-
vel of up to 90 °fH (French grading) or 50 °dH (German
grading) through 8 settings. The settings are listed in
the table below, with the relative mains water to be
treated.
* The softener unit is set in the factory at level 4 (S4) as
Regulate the setting of your water softener unit
according to the degree of hardness of your water, as
follows:
The dishwasher must ALWAYS be o before start of
this procedure.
• Switch on the dishwasher with the “ON/ OFF”
button.
• Keep the “SETUP 5 SEC” button pressed for about
5 sec.
• The “SETTINGS” message appears on the display.
• By pressing the “PROGRAM SELECTION” key
you can select the successive parameters to be
adjusted.
• Select the “SOFTENER” setting.
• Press the “START/OK”
selected parameter.
• The set level appears on the display (the facto-
ry-set level is “S4”).
• Press the “PROGRAM SELECTION” buttons to
• “START/OK”.
• “SOFTENER” will scroll on the display.
• To exit the menu, press the “ON/ OFF” key.
To change the water softener setting again, follow the
same procedure.
Water softener
Level
Water hardness
Use of
0 0-5 0-3 NO S 0
1 6-1 0 4-6
YES
S 1
2 1 1 -20 7 -1 1 YES S 2
3 21 -30 1 2-1 6 YES S 3
4* 31 -40 1 7-22 YES S 4
5 41 -50 23-27 YES S 5
6 51 -60 28-33 YES S 6
7 61 -90 34-50 YES S 7
To Next Page
Loading...
