English
20
FLOOR LIGHT
When the wash cycles are started, the light stays on
until the end of the wash cycle. To indicate the end of
-
ly for 10 sec.
The light is not active when the machine is in the
delayed start or pause condition.
The indication will not be visible if the plinth panel is
positioned forward or if something is placed in front of
the information projector.
AUTO DOOR OPEN button
This option activates a special device that opens the
door a few centimeters during or at the end of the
drying cycle (depending on the programmes), favou-
The duration of the selected cycle will be automatically
consumption. Opening the door in the last stage of
drying enables air to be recirculated, eliminating the
risk of unpleasant odours.
This option will automatically be active in the “ECO”
programme.
There is however the option to deactivate it.
WARNING: With this option selected, you
must not in any way prevent the door from
opening or force it to close, so as not to dam-
age the mechanism. Leave the space in front
of the door free and before closing it, wait for
the opening device to reactivate.
“NO SALT” warning light
When the “SALT” message appears on the display or,
where present, the relative light comes on
tank (see chapter on “ADDING THE SALT”).
If the setting level of the softener is set to 0, this will
never happen (see chapter on setting the softener).
“NO RINSE AID” warning light
When the “RINSE AID” message appears on the
display or, where present, the relative light comes
“LOADING RINSE AID”).
If the RINSE AID level is set to 0, this will never
happen.
DELAY START button
Delay start selection:
This button allows you to programme the start of the
wash cycle, with a delay between 0:30 and 24 hours.
To set the delayed start proceed as follows:
- Switch on the dishwasher by pressing and
holding the “ON/OFF” button for about 3
seconds.
- Select the washing programme.
- Press the “DELAY START” button (“0:30” will
appear on the display).
- Press the button again to increase the
delay by 30 minutes, after each time the
button is pressed it will increase by 1 hour
up to a maximum of 24:00. Pressing the
button again after a delay of 24:00 will
return to 0:00 (delayed start disabled).
- The delayed start settings will remain
visible on the display for 5 seconds, or
until the ON/OFF - PRO GRAM SELECTION -
START/OK buttons are pressed.
To Next Page
Loading...
