© 2018 imc Test & Measurement GmbH
imc C-SERIES - Manual, Version 4 R 3 - 2018-10-19
10 General
1.8.2 Operating personnel
·
Danger of injury due to inadequate qualifications!
·
Improper handling may lead to serious damage to personnel and property. When in doubt, consult
qualified personnel.
·
Work which may only be performed by trained imc personnel may not be performed by the user. Any
exceptions are subject to prior consultation with the manufacturer and are conditional on having
obtained corresponding training.
The manual distinguishes the following degrees of qualification for performing various actions:
·
Users of the measurement equipment. Fundamentals of measurement engineering. Recommended:
knowledge of foundations of electrical engineering. Familiarity with the Microsoft Windows
operating system. Users may not open or modify the device.
·
Qualified personnel is able, due to training in the field and to possession of skills, experience and
familiarity with the relevant regulations, to perform work assigned while independently recognizing
any hazards.
1.8.3 Special dangers
This segment states what residual dangers have been identified by the hazard analysis. Observe the
safety notes listed here and the warnings appearing in subsequent chapters of this manual in order to
reduce health risks and to avoid dangerous situations.
·
Lethal danger from electric current!
·
Contact with conducting parts is associated with immediate lethal danger.
Damage to the insulation or to individual components can be lethally
dangerous.
Therefore:
·
In case of damage to the insulation, immediately cut off the power supply and
have repair performed.
·
Work on the electrical equipment must be performed exclusively by expert
electricians.
·
During all work performed on the electrical equipment, it must be deactivated
and tested for static potential.
·
Injuries from hot surfaces!
·
Devices from imc are designed so that their surface temperatures do not
exceed limits stipulated in EN 61010-1 under normal conditions.
Therefore:
·
Surfaces whose temperature can exceed the limits under circumstances are
denoted by the symbol shown at left.
To Next Page
Loading...
Need help?
General
