To Next Page

To Previous Page

imc C-SERIES - Manual, Version 4 R 3 - 2018-10-19

11After unpacking...

1.9 After unpacking...

Check the delivered system immediately upon receiving it for completeness and for possible transport

damage. In case of damage visible from outside, proceed as follows:

Do not accept the delivery or only accept it with reservations

Note the extent of the damage on the packing documents or on the delivery service's packing list.

Begin the claims process.

Please check the device for mechanical damage and/ or loose parts after unpacking it. The supplier must

be notified immediately of any transportation damage! Do not operate a damaged device!

Check that the list of accessories is complete :

AC/DC-power adaptor (not for racks) with cable and pre-assembled LEMO connector

DC-power LEMO connector

DSUB-15 connectors:

1x ACC/DSUBM-DI4-8, 15-pin DSUB clamp connector for 8 digital inputs

1x ACC/DSUBM-DO8, 15-pin DSUB clamp connector for 8 digital outputs

1x ACC/DSUBM-ENC4, 15-pin DSUB clamp connector for 4 incremental counter inputs

1x ACC/DSUBM-DAC4, 15-pin DSUB clamp connector for 4 analog outputs

Connector set corresponding to the device's built-in amplifier (see corresponding data sheet)

Getting started with your imc measurement device (printed)

Note

File a claim about every fault as soon as it is detected. Claims for damages can only be honored within

the stated claims period.

1.10 Transport

When transporting imc C-SERIES, always use the original packaging or a appropriate packaging which

protects the device against knocks and impacts. If transport damages occur, please be sure to contact the

imc Customer Support. Damage arising from transporting is not covered in the manufacturer's guarantee.

Possible damage due to condensation can be limited by wrapping the device in plastic sheeting.

1.11 Storage

As a rule, the measurement device can be stored at temperatures ranging from -20°C to +85°C.

1.12 Cleaning

Always unplug the power supply before cleaning the device. Only qualified service technicians are

permitted to clean the housing interior.

Do not use abrasive materials or solutions which are harmful to plastics. Use a dry cloth to clean the

housing. If the housing is particularly dirty, use a cloth which has been slightly moistened in a

cleaning solution and then carefully wrung out. To clean the slits use a small soft dry brush.

Do not allow liquids to enter the housing interior.

Be certain that the ventilation slits remain unobstructed.

IMC C SERIES User Manual

Questions and Answers: