To Next Page

To Previous Page

imc C-SERIES - Manual, Version 4 R 3 - 2018-10-19

20 Start of operation Software / Firmware

Select Version 4 of the Internet Protocol Version 4 (TCP/IP4) and click on Properties. Now the current

settings are visible. Please note the computer's IP address (3) and the subnet mask (4).

Select Internet Protocol (TCP/IP)

Settings for TCP/IP

Warning

Be careful in changing settings, since if the same network card is used, there may be difficulties later

in the company network. Please discuss this with your responsible administrator/IT-service.

Note: Obtain IP-address automatically (DHCP)

If "Obtain IP address automatically" (DHCP) is selected, no IP address is displayed. In this case, you

have to determine the current IP-address using the Command Prompt/Command line.

Note, however, that automatically obtained IP-addresses might change the next time the operating

system is started!

Questions and Answers:

Need help?

Do you have a question about the IMC C SERIES and is the answer not in the manual?

IMC C SERIES Specifications

General