To Next Page

To Previous Page

imc C-SERIES - Manual, Version 4 R 3 - 2018-10-19

6 General

Note

The EMC tests were carried out using shielded and grounded input and output cables with the

exception of the power cord. Observe this condition when designing your experiment to ensure high

interference immunity and low jamming.

If you are located outside Europe, please refer the appropriate EMC standards used in the country of operation.

FCC-Note

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules (CFR 15.105)

. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment on and off, the user is encouraged to try to correct the interference by one or more of the

following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

Consult our imc hotline or an experienced radio or television technician for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that

are not expressly approved by imc may void the user's authority to operate this equipment.

FCC - United States Federal Communications Commission

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods

to maintain compliance with FCC Rules and Regulations.

Industrial Safety

We certify that imc C-SERIES in all product configuration options corresponding to this documentation

conforms to the directives in the accident prevention regulations in "Electric Installations and

Industrial Equipment" (DGUV Regulation 3)

This certification has the sole purpose of releasing imc from the obligation to have the electrical

equipment tested prior to first use (§ 5 Sec. 1, 4 of DGUV Regulation 3). This does not affect

guarantee and liability regulations of the civil code.

Formerly BGV-A3

IMC C SERIES User Manual

Questions and Answers: