1
COPYRIGHT NOTICE
Copyright 2002 Imerge Ltd. All rights reserved.
The NP200 and this documentation are copyright
materials. No part of the SoundServer software or this
documentation may be reproduced, transmitted,
transcribed, stored in a retrieval system, or translated
into any language, or computer language, in any form or
by any means without prior written permission of
Imerge.
XiVA is a registered trademark of Imerge Ltd. All other
product names are trademarks or registered trademarks
of their respective owners.
Net-tune is a trademark of the Onkyo Corporation.
MPEG Layer-3 audio coding technology licensed from
Fraunhofer IIS and THOMSON multimedia.
The information in this guide is believed to be correct as
of the date of publication. However our policy is one of
continuous development and so the information in this
guide is subject to change without notice, and does not
represent a commitment on the part of Imerge.
This guide was designed and produced by Imerge Ltd.
XIVA™ NEW MEDIA BROUGHT TO LIFE
XiVA™ is a highly portable software framework that
powers next-generation media appliances. XiVA™
blends hard disk technology, advanced software design,
and embedded Internet technology to provide amazing
features. Audio, video, text, graphics, and all forms of
streaming new media are all brought to life through a
wealth of interactive user interface options. The next
generation media appliance is powered by XiVA™.
PRECAUTIONS
GENERAL PRECAUTIONS
When installing the equipment ensure that:
– the ventilation holes are not covered.
– air is allowed to circulate freely around the
equipment.
– it is placed on a vibration free surface.
– it will not be exposed to excessive heat, cold,
moisture or dust.
– it will not be exposed to direct sunlight.
– it will not be exposed to electrostatic discharges.
In addition, never place heavy objects on the equipment.
If a foreign object or water does enter the equipment,
contact your nearest dealer or service center.
Do not pull out the plug by pulling on the mains lead;
grasp the plug.
It is advisable when leaving the house, or during a
thunderstorm, to disconnect the equipment from the
mains supply.
WARNING:WARNING:
WARNING:WARNING:
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
Do not remove the cover from the equipment. There are
no user serviceable parts inside, and opening the case
will invalidate your warranty.
Do not insert anything into the equipment through the
ventilation holes.
Do not handle the mains lead with wet hands.
To avoid overheating do not position the NP200 near
heat sources, and ensure that the ventilation holes are
not blocked.
WARNINGS
Do not expose the equipment to rain or moisture.
Do not remove the cover from the equipment.
Do not insert anything into the equipment through
the ventilation holes.
Do not cover the ventilation holes with any items such
as tablecloths, newspapers, curtains, etc.
Do not place naked flame sources, such as lighted
candles, on the equipment.
Do not handle the mains lead with wet hands.
Allow adequate ventilation. Leave a gap of 0.2m on
all sides of the unit.
Do not splash or spill water on the unit. Do not place
objects filled with liquid (such as vases) on the unit.
MAINS PRECAUTIONS
Your NP200 complies with the household power and
safety requirements in your area.
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.READ THE FOLLOWING SECTION CAREFULLY.
READ THE FOLLOWING SECTION CAREFULLY.READ THE FOLLOWING SECTION CAREFULLY.
READ THE FOLLOWING SECTION CAREFULLY.
There is a voltage selector (2-position) on the rear panel
of this unit. Be sure to set the voltage selector to the
mains voltage of your area before using the unit.
IMPORTANT: (FOR UK VERSION ONLY)
This apparatus is fitted with an approved moulded 13
Amp plug. To change a fuse in this type of plug proceed
as follows:
1 Remove fuse cover and fuse.
2 Fix new fuse which should be a BS1362 5A,
A.S.T.A or BSI approved type.
3 Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a
value of 5A. If a plug without a fuse is used, the fuse at
the distribution board should not be greater than 5A.
NOTE: NOTE:
NOTE: NOTE:
NOTE: The severed plug must be destroyed to avoid a
possible shock hazard should it be inserted into a 13A
socket elsewhere.
COPYRIGHT NOTICE
This equipment must not be used for unauthorised
duplication of CDs or any other works protected by
copyright. No license to infringe copyright is granted
by the sale of this equipment.
Recording and playback of some material may require
permission. For further information refer to the
following:
– Copyright Act 1956
– Dramatic and Musical Performers Act 1958
– Performers Protection Acts 1963, and 1972
– Any subsequent statutory enactments and orders.
STANDBY BUTTONSTANDBY BUTTON
STANDBY BUTTONSTANDBY BUTTON
STANDBY BUTTON
When this button is pressed once, the power turns
OnOn
OnOn
On
and information will appear on the display. When
pressed again, the unit is in
OffOff
OffOff
Off mode and the
Standby Standby
Standby Standby
Standby indicator is lit; the apparatus is not
disconnected from the AC mains supply in this mode.
To Next Page
Loading...