Imerge NP200 - Standby Display Brightness; FM;AM Frequency Step

19
NoteNote
NoteNote
Note: The ID should match the ID set for the remote
control; see To change the remote control code , page 6.
SETTING THE STANDBY DISPLAY
BRIGHTNESS
• Press the £
SETUPSETUP
SETUPSETUP
SETUP key to display the Setup
menus.
• Use the a and v keys to highlight
SystemSystem
SystemSystem
System and
press the »
SELECTSELECT
SELECTSELECT
SELECT key.
• Use the a and v keys to highlight
DisplayDisplay
DisplayDisplay
Display
StandbyStandby
StandbyStandby
Standby and press the »
SELECTSELECT
SELECTSELECT
SELECT key.
• Use the a and v keys to select between
BrightBright
BrightBright
Bright,
DimDim
DimDim
Dim, or
OffOff
OffOff
Off.
• Press the »
SELECT SELECT
SELECT SELECT
SELECT key to save the change.
• Press the £
SETUP SETUP
SETUP SETUP
SETUP key to exit from the Setup
menus.
CHANGING THE FM/AM FREQUENCY STEP
The FM/AM frequency step can be toggled between 50k/
9k steps and 100k/10k steps depending on the
configuration for your country.
Note:Note:
Note:Note:
Note: Changing this option will delete any presets you
have saved.
• Press the £
SETUPSETUP
SETUPSETUP
SETUP key to display the Setup
menus.
• Use the a and v keys to highlight
FM/AM FreqFM/AM Freq
FM/AM FreqFM/AM Freq
FM/AM Freq
StepStep
StepStep
Step and press the »
SELECTSELECT
SELECTSELECT
SELECT key.
• Use the a and v keys to change the frequency
step.
• Press the »
SELECT SELECT
SELECT SELECT
SELECT key to save the change.
• Press the £
SETUP SETUP
SETUP SETUP
SETUP key to exit from the Setup
menus.