Industrial Data Systems IDS 440 - Diagnostic Tests; Table of Diagnostic Tests

IDS440 Users Manual version 4.2 Diagnostic Tests
52
Diagnostic Tests
The DIAGNOSTIC TESTS are accessed using configuration function 69. Hold the
CLEAR key down and press the ENTER key. The display prompts “CFG xx” where xx
is the currently selected parameter. Enter 69 and press the ENTER key to access the
DIAGNOSTIC TESTS.
The display prompts “diA xx” where xx is the last selected diagnostic function. Select a
test number from the table below. Enter the test number and press the ENTER key.
Table of Diagnostic Tests
Test No. Hardware Tested Description
1 Serial Com. Port 1 Display input data.
2 Serial Com. Port 1 Display input error count.
3 Serial Com. Port 1 Transmit data.
4 Serial Com. Port 2 Display input data.
5 Serial Com. Port 2 Display input error count.
6 Serial Com. Port 2 Transmit data.
7 Parallel Port Transmit data.
8 A/D converter Display raw conversion data.
9 Ram Memory Test memory for errors.
10 Display Turn on all LED’s and display segments.
11 Configuration Print the EAROM configuration data.
12 Serial Com. Port 1 Transmit/Receive loop-back test.
13 Serial Com. Port 2 Transmit/Receive loop-back test.