25
Smart tip: Massage Width can’t be
adjusted when in Kneading, or Sync mode
techniques. Massage Speed can’t be
adjusted when in Shiatsu.
Focus Zone
Controls the range of motion of the back mechanism, Whole travels the entire length of the
track, Partial travels a short distance and reverses direction for focused relief, Point stops
on the track for targeted relief. Tap screen to select setting.
Adjust: Partial and Point location can be fine tuned by using the Adjust setting. Use the
arrow up or arrow down buttons to control the location of the back mechanism.
Massage Width
Increase or decrease width of back mechanism. Choose from: Narrow, Medium, or Wide
(Width can’t be adjusted when in Kneading, or Sync modes).
Tap screen to select setting.
Maximum 4D Level
Use this control to increase or decrease the maximum intensity of the 4D back mechanism
that works the neck and shoulder region. This setting will set the upper limit of the 4D
fluctuations throughout your massage. 1 = light, 5 = firm, or Off. Tap screen to select setting.
Foot Rollers & Calf Oscillation
Control Total Sole Reflexology™ Foot Rollers and
Complete Calf
™
Calf Rollers & Oscillation.
Choose your desired speed: 1 = slow, 2, 3 = fast, or Off (deactivate foot rollers).
Tap screen to
select setting.
Back Heat
Activate back heat and choose your desired heat intensity level: 1 = low, 2, 3 = high, or Off
(deactivate back heat). Tap screen to select setting.
Air Settings
Choose your desired airbag region/s: Full, Arm & Shoulders, Back & Waist, Leg & Foot, or
Buttock. Tap screen to select setting. To turn a particular airbag region off, de-select the
activated region. Selecting Full will over ride any selections and ALL airbags become active.
Massage Speed
Increase or decrease speed of back mechanism. 1 = slow, 5 = fast (massage speed can’t be
adjusted when in Shiatsu Manual mode).
Tap screen to select setting.
Max Air Intensity
Increase or decrease maximum intensity of airbag massage. All auto massages are pre-
programmed to have varying levels of airbag intensity, this setting will set the upper limit of
these fluctuations. 1 = light, 5 = firm, or Off. Tap screen to select setting.
To Next Page
Loading...
