Infoblox SoT 1405 Series Rack Mounting Procedures
For the Infoblox 1400 Series Platforms 21
Figure 9 Chassis Slide Rail and Rack Slide Bracket
4. Align the mounting holes on the chassis slide rails with the rear-most mounting holes on each side of the
chassis. Ensure that you place the chassis slide rails in the correct orientation. Otherwise, the mounting holes
do not align correctly.
5. Attach the chassis slide rails to each side of the chassis with two (2) 8-32 screws, as shown in Figure 8.
6. Select a desired location and secure the rack slide brackets to the rear posts of the equipment rack with two
(2) 10-32 screws on each side of the rack.
7. With one person on each side, lift the appliance and position it in front of the equipment rack.
8. Align the chassis slide rails on the appliance with the rack slide brackets on the posts of the equipment rack.
9. Slide the appliance into the rack slide brackets.
10. Secure the rack ears to the rack with two (2) 10-32 screws on each side of the rack.
Adjustable Rail Four-Post Rack Mounting
Infoblox provides an adjustable four-post rail kit with 600mm to 900mm depth adjustment, designed to allow one
person to perform physical installation of the rack kit and the appliance. This kit is provided as a field-replaceable
unit; for information, see the section
Replaceable Unit and SFP Part Numbers in this Guide. The adjustable rail kit
is designed to allow one person to perform the physical installation of the rail kit and the appliance.
The adjustable rail kit is designed for tight vertical spaces on the interior of a four-post rack, allowing for appliance
installation in restricted rack spaces, including 1U of available rack space.
The adjustable rail kit includes the following items for installation:
• Eight (8) Flat-head beveled 8/32” screws that attach rail pieces to the appliance chassis
• Eight (8) Phillips-head 10/32” screws for affixing the rack rails to the four-post rack
The technician must provide four attachable cage nuts for adapting the square mounting holes on the rear posts of
the four-post rack to accept the 10/32” screws.
To install the adjustable rail kit, do the following:
1. Install the cage nuts in the rear rack posts in the desired location, as indicated in Figure 10.
Chassis Slide Rail
Rack Slide Bracket
Towards rear posts
To Next Page
Loading...
Need help?
General
