InFocus IN3118HD - Adjusting the Projector Level

IN3118HD User’s Manual
Adjusting the Projector Level
Take note of the following when setting up the projector:
• The projector table or stand should be level and sturdy.
• Position the projector so that it is perpendicular to the screen.
• Remove and discard the foam spacer on the rear leveling foot before adjusting the projec-
tion angle.
• Ensure the cables are in a safe location. You could trip over them.
C
B
A
D
1.
To raise the level of the projector, lift the projector [A] and press the elevator
button [B].
The elevator foot drops down [C].
2.
To lower the level of the projector, press the elevator button and push down
on the top of the projector.
3.
To adjust the angle of the picture, turn the leveling foot [D] right or left until
the desired angle has been achieved.
– 10 –