35
number, you must enter 5 numbers and press the Select button in order to access the
“Wrong PIN” message and re-enter the code.
To enter the PIN at projector startup:
Power up the projector. The “Enter PIN” d
ialog box appears after the startup screen.
Enter the PIN. Use the navigation buttons on the remote or keypad to enter the
correct button press sequence. See the description above for instructions.
To change the PIN:
Select “Change PIN...” in the
Setup menu. Enter the existing PIN. Enter the new
PIN. You can navigate between OK and Cancel by pressing the up and down
buttons on the keypad. Select OK or Cancel by pressing the Select button. Verify
the new PIN.
If you lose or forget your custom PIN: Contact InFocus support. Go to
www.infocus.com/support
Serial Port Baud Rate: selects the serial port and baud rate.
Serial Port Echo: contr
ols whether the serial port echoes characters.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
