InFocus IN3916 User Manual

8
Displaying an image
Touch the Power button.
The Power button blinks green and the fans start to run. When the lamp comes on,
the start up screen displays and the Power button is steady green. It can take up to a
minute for the image to achieve full brightness.
? No start up screen? Get h
elp on page 17.
Turn on your computer or video device.
The image should appear on the projection
screen. If it doesn’t, press the Source
button on the projector’s keypad or remote.
If you are using a VGA cable to connect
your computer to the projector:
If using a laptop, make sure its external video p
ort is active.
Many laptops do not automatically tur
n on their external video port when a
projector is connected. Usually a key combination like FN + F8 or CRT/LCD key
turns the external display on and off. Locate a function key labeled CRT/LCD or a
function key with a monitor symbol. Press FN and the labeled function key
simultaneously.
Refer to your laptop's documentation for more information about your
lapt
op's key com
bination or go to the InFocus website at: http://
www.infocus.com/Support/LaptopActivation.aspx.
? No laptop image? Tr
y pressing the Auto Image button on the keypad. Get
help on page 17.
press Power button
turn on computer or
video device
activate laptop’s external port
monitor key or
LCD/CRT key
FN key

InFocus IN3916 Specifications

General

Projection distance	0.75 - 1.65 m
Vertical scan range	23.5 - 85 Hz
Horizontal scan range	31.4 - 91.1 kHz
Projection technology	DLP
Contrast ratio (typical)	3200:1
Screen size compatibility	1.44 - 3.17 \
Projector native resolution	WXGA (1280x800)
Keystone correction, vertical	± 30 °
Resolution	1920 x 1200 pixels
Aspect ratio	16:10
RS-232 ports	1
Weight (imperial)	9.9 lbs
Dimensions (WxDxH)	320 x 251.5 x 127 mm
Power requirements	90-264V, 50/60Hz
Connectivity technology	Wired
Focal length range	- mm
Lamp power	220 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	4000 h
HD-Ready	Yes
Analog signal format system	NTSC, PAL, SECAM
RMS rated power	10 W
Number of built-in speakers	2
DVI port	No
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
S-Video inputs quantity	0
VGA (D-Sub) ports quantity	3
Noise level	35 dB
Certification	UL, c-UL, FCC, CE, C-Tick Mark, NOM, COFETEL
Power source	AC
Power consumption (standby)	- W
Power consumption (typical)	238 W
Operating temperature (T-T)	5 - 40 °C
Product type	Standard throw projector

Weight and Dimensions

Weight	4490 g
Package weight	6580 g