User’s Manual
8.
Reverse steps 1 to 7 to
install the new lamp
module.
While installing, align the
lamp module with the
connector and ensure it is
level to avoid damage.
Note:
The lamp module must sit
securely in place and the
lamp connector must be
connected properly before
tightening the screws.
9.
Turn on the projector and reset the lamp after the lamp module is replaced.
Lamp Reset:
Press Menu → Select Installation II / Advanced → Select Lamp Hour Reset → Press
the ◄► buttons to adjust the settings.
– 44 –
To Next Page
Loading...
