IN5312/IN5314 – User’s Manual
– 47 –
LED Error Messages
Error Code Messages PWR LED TEMP LED READY LED
Over temperature Off Solid Red Off
Thremal break Flashing Red 4x Off Off
Lamp strike fail Flashing Red 5x Off Flashing Red 1x
Ballast said Lamp off Flashing Red 5x Off Flashing Red 2x
Ballast said OVT when Lamp strike Flashing Red 5x Off Flashing Red 3x
Ballast said OVT when SYS operation Flashing Red 5x Off Flashing Red 4x
Fan 1 error Flashing Red 6x Off Flashing Red 1x
Fan 2 error Flashing Red 6x Off Flashing Red 2x
Fan 3 error Flashing Red 6x Off Flashing Red 3x
Case open Flashing Red 7x Off Off
DMD fail Flashing Red 8x Off Off
Color wheel fail Flashing Red 9x Off Off
Ballast Communication Fail Flashing Red 10x Off Flashing Red 1x
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before re-
starting the projector. If the PWR or READY LED is still blinking or the TEMP LED is lit, contact
InFocus Technical Support at www.infocus.com/support
.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
3. Many laptops do not automatically turn on their external video port when a projector is
connected. Usually a key combination like FN + F8 or CRT/LCD key turns the external
display on and off. Locate a function key labeled CRT/LCD or function key with a monitor
symbol. Press FN and the labeled function key simultaneously.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto Image button on the remote control.
3. Ensure the projector-to-screen distance is within the projection range. (Within 7m/23' for
the standard lens; within 20m/66' for the long lens and within 3m/10' for the short lens).
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone buttons on the remote control or projector to correct the problem.
Problem: The image is reversed
Check the Projection setting on the Image menu of the OSD.
To Next Page
Loading...
Need help?
General
