User’s Manual
Starting and Shutting down the Projector
1.
Remove the lens cap.
2.
Connect the power cord to the pro-
jector. Connect the other end to a
wall outlet. Verify that the AC Power
switch on the back of the unit is
turned on. When connected, the
PWR LED will turn solid amber.
3.
Turn on the lamp by pressing the
“
” button on the rear of the
projector or the Power On button on
the remote.
The PWR LED will now flash amber.
The startup screen will display in
approximately 30 seconds.
Note:
The first time you use the projector,
you can select your preferred lan-
guage from the Quick menu after
the startup screen displays.
– 12 –
To Next Page
Loading...
Need help?
General
