41
Manual Sync
The projector adjusts signal synchronization automatically for
most computers. But if the projected computer image looks fuzzy
or streaked, try turning
Auto Image
off then back on again. If the
image still looks bad, try adjusting the signal synchronization
manually:
1 Turn Auto Image off.
2 Move the slider to adjust Manual sync until the image is sharp
and free of streaks.
Manual Tracking
The projector adjusts tracking automatically to match the video
signal from your computer. However, if the display shows
evenly spaced, fuzzy, vertical lines or if the projected image is too
wide or too narrow for the screen, try turning
Auto Image
off then
back on again. If the image is still bad, try adjusting the tracking
manually:
NOTE: The Manual Sync,
Manual Tracking, Horiz. Posi-
tion and Vert. Position options
are available only for analog com-
puter sources. The projector sets
these options automatically for dig-
ital computer and video sources.
1 Turn Auto Image off.
2 Move the slider to adjust Manual tracking until the fuzzy ver-
tical bars are gone.
Horizontal position
Follow these steps to manually adjust the horizontal position:
1 Turn Auto Image off.
2 Move the slider to adjust the Horizontal position.
Positioning adjustments are saved when you power off the pro-
jector.
Ver tical po s ition
Follow these steps to manually adjust the vertical position.
1 Turn Auto Image off.
2 Move the slider to adjust the Vertical position.
To Next Page
Loading...
