INFOSEC UPS SYSTEM E4 Evolution II TT Series - Page 103

102
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 02 19 AA 59 203 07
Factory Reset
--
Restore to factory default setting
Refer to Table 3-7
EEPROM
Reset
--
Restore EEPROM to default setting
Refer to Table 3-7
EPO Function
--
Set EPO active status
 Normal Close Active
 Normal Open Active (Default)
Password
--
Set New Password.
0000 (Default)
Save Setting
--
Save all settings to EEPROM.
Use this feature to save the setting(s) you have done.
Startup
Screen
Set up initial screen. (xxxxxxxxxxxx).
The max. length is 12 characters.
EEPROM Reset Category List
Setting Item
Factory Reset
EEPROM Reset
General
Model Name
Language
Y
Y
Adjust Time
System Installed Date
Y
System Last Maintain Date
Y
Battery Installed Date
Y
Battery Last Maintain Date
Y
Change Password
Y
Baud Rate
Y
Audible Alarm
Y
Y
Factory Reset
--
--
EEPROM Reset
--
--
EPO Function
Y
Save Setting
--
--
Startup Screen
System
Output Voltage
Y
Bypass Voltage Range
Y
Y
Bypass Frequency Range
Y
Y
Converter Mode
Y
Y
ECO Mode
Y
Y
Bypass Mode
Y
Y
Auto-Restart
Y
Y
Cold Start
Y
Battery Mode Delay Time
Y
Y
System Shutdown Time
Y
Y
System Restore Time
Y
Y
Charger Test
--
--
Redundancy
Y
Battery
Nominal Battery Voltage
Y
Y
Battery Capacity in Ah
Y
Y
Maximum Charging Current
Y
Y
Battery Low/Shutdown Setting
Y
Y
Periodic Battery Test
Y
Y
Battery Test Interval
Y
Y
Stop by Time
Y
Y
Stop by Battery Voltage
Y
Y
Stop by Battery Capacity
Y
Y
Battery Age Alert
Y
Y
Temperature Compensation
Y
Y
Charging Voltage
Y
Y
Auto-Restart Battery Voltage
Y
Y
Pre-Alarm
Y