APOS A8
05/18
Copyright© 2018 Ingenico
All rights reserved
16
4_3_2 Installing paper roll
Open the paper cover by lifting the catch located at the top of
APOS A8 and pull the cover to the rear of the terminal.
Insert the paper roll in the compartment following the directions
shown on the below picture.
Pull the paper up to the top of terminal, maintain the paper and
close the cover
Press simultaneously on both upper corners of the paper ap
until it clips into position.
If you insert a new R40 paper roll, tear off the rst length
(one complete turn to avoid printing on adhesive footprint).
ADVICE
Switch off the terminal prior to installing a paper roll. Use
only paper approved by Ingenico.
The use of no-approved paper is likely to damage the printer
of your terminal.
WARNING
To Next Page
Loading...
Need help?
General
