APOS A8
05/18
Copyright© 2018 Ingenico
All rights reserved
17
When does the battery need to be charged?
How can the battery be charged?
When used daily, the terminal charges its battery each
time the power adapter is connected. Charging starts
automatically.
Using the power adaptor
Connect the power adapter to the terminal micro USB type
A connector located on the left side of the terminal.
Connect the power adapter to the power supply mains
network.
Check if the Red LED at the top of front is lighted (it means
battery charging).
Locate the battery pack connector beside the battery
compartment
Plug the battery pack connector according to the connector
locating system.
Place the battery pack in its compartment
Close the battery trapdoor.
Check that the terminal is not connected to the main electric
network.
WARNING
4_4 Battery
4_4_1 Charging the battery
Turn your terminal and unclip the battery trapdoor by pushing the
clips as shown with the arrow on the picture.
Disengage the trapdoor.
Take the battery pack included in the box
4_4_2 Installing the battery
To Next Page
Loading...
