Page 10
Copyright© 2019 Ingenico
Using the terminal keyboard & display
To enter numbers press the relevant keys. If you make a mistake you can
correct this using the correction keys. Press the yellow button once to delete
one character at a time. Press the red button once to delete the entire line;
pressing the red button again will cancel the transaction or exit the menu.
When typing in an authorisation code, for example, you may need to enter
letters as well as numbers. Where you see the 123 graphic (see below) on
screen you can toggle the input mode by pressing the function ( ) button.
To enter uppercase letters use the ABC input mode, and to enter lowercase
letters use the abc input mode.
When entering letters, you should press the number key repeatedly until the
desired letter appears. For example, if you want to type B then you must press
2, 2. To move on to next character either press another key, or wait for the
flashing cursor to appear.
Terminal is in the lowercase letter mode, mode is changed by
pressing button
Terminal is in the uppercase letter mode, mode is changed by
pressing button
Terminal is in the numeric mode, mode is changed by pressing
button
Supervisor Code
The default Supervisor Code is 01483. Please note: The terminal will require
you to change this to a new code of your choosing before you can process any
transactions.
To Next Page
Loading...
Need help?
General
