Page 19
Copyright© 2019 Ingenico
Mailorder Transactions (Customer Not Present)
You must ensure that this option is enabled on your acquirers
Merchant Account.
Your terminal is pre-configured for Mailorder (Customer Not Present)
transactions.
Mailorder transactions are performed without the customer or the card being
present. All card details must be manually entered so please take note of what
information will be asked for by your terminal. If supported by your acquirer and
by the card type taken, you will have the option of entering the CSC (Card
Security Code) and using the AVS (Address Verification Service).
The CSC is the last three digits of the number printed on the signature strip on
the back of the card. To use AVS checking, you will be prompted to input only
the digits from the customer’s postcode and address.
For American Express cards there is a four digit Card Security
Code printed on the front of the card, any numbers on the
signature strip should be ignored.
The response from the acquirer will then give you the result of the security
checks to help you decide if you wish to continue with the transaction.
Mailorder - CSC/AVS Results
Please be aware that the CSC/AVS result is intended only to guide you in a
decision to void or confirm an already authorised transaction. Contact your
acquirer for more information and details of liability.
DATA MATCHED
Both the CSC and AVS data matches.
AVS MATCH ONLY
Only the AVS data matches.
CSC MATCH ONLY
Only the CSC data matches.
DATA NON MATCH
Neither the CSC nor AVS data matches.
NOT CHECKED
The data was not checked.
The data may not be checked if the service is not supported or if there is a
temporary system failure.
To Next Page
Loading...
Need help?
General
