Page 41
Copyright© 2019 Ingenico
Security of the terminal
This device fulfils current applicable PCI PTS security requirements. Upon
receipt of the terminal you should check for signs of tampering of the
equipment. It is strongly advised that these checks are performed regularly
after receipt. Check, for example: that the keypad is firmly in place; that there
is no evidence of unusual wires that have been connected to any ports on
the terminal or associated equipment, the chip card reader or any other part
of the terminal. Such checks would provide warning of any unauthorised
modifications to the terminal, and other suspicious behaviour of individuals
that have access to your terminal. The terminal detects any “tampered state”.
In this state the terminal will repeatedly flash the message ”Alert Irruption!”
and further use of the terminal will not be possible. If the “Alert Irruption!”
message is observed, contact the terminal helpdesk immediately.
It is strongly advised that privileged access to the terminal is only granted to
staff that have been independently verified as being trustworthy.
The terminal must never be put in or left at a location where it could be stolen
or replaced by another device.
To Next Page
Loading...
Need help?
General
