Ingrasys iED N Series - Connecting to a Network

User’s Manual
3.2 Connecting to a Network
The iED N-002 can be connected to an Ethernet network with a RJ-45 cable as shown below.
Connect the iED N-002 to an Ethernet hub or switch with a RJ-45 cable.
3.3 Connecting to iED S-201 (RS485 HT sensor)
The iED N-002 can be connected to iED S-201 (RS485 HT Sensor) with 3 wires by RS485 for
communication and with 2 wires for power as shown below.