1. Preface
1.1 About this Manual
This manual provides instructions for installing the iED N-002 on your network and for configuring
the network. It is suggested to read this manual according to the sequence of the Table of Contents
in order to avoid any setting errors.
1.2 Safety Precautions
1. Do not attempt to disassemble the equipment in order to avoid electrical shock or irreparable
damage to internal parts.
2. Do not place the equipment outdoors in rain or in locations with high humidity in order to protect
electronic components from short circuit.
3. Installation and maintenance of this equipment should be handled by professional technicians.
4. Make sure the equipment and its accessories are secured properly to prevent it from falling to the
ground and being damaged.
5. Use only the power adaptor and accessories included in the package, alternative brands may
damage the equipment.
6. Follow the instructions in this manual to connect the power adaptor and avoid improper use of
the equipment. Make sure all the cables are connected correctly before turning on the power.
7. Do not use any organic solutions or corrosive detergents to clean the exterior of the equipment.
To clean the equipment, first turn off the power. Use a cloth that has been lightly dampened in
water to clean the exterior.
8. Do not use the equipment in the following environments:
● Humidity higher than 100%.
● Temperature higher than 70°C or lower than -20°C.
● Near objects which transmit strong electromagnetic waves (e.g. televisions or radios).
● Locations subject to violent shaking.
● Locations that are damp or that come in contact with water.
To Next Page
Loading...
Need help?
General