Ingrasys iED N Series User Manual

User’s Manual
5.3.1 TCP/IP
This page allows the administrator to set the local network configuration parameters.
Enable DHCP
This is the parameter enabling the Dynamic Host Configuration Protocol (DHCP)
process. This protocol are used to obtain a dynamic IPv4 address from a DHCP server
otherwise not.
5.3.2 IPv4 Setting
IP Address
This field allows the administrator to view the present setting or set the IPv4 address of
iED N-002 and only accept “dotted decimal notation” format (i.e., 192.168.60.229).
Subnet Mask
This field allows the administrator to view the present setting or set the subnet mask of
iED N-002 and only accept “dotted decimal notation” format (e.g.: 255.255.255.0)
Gateway
This field allows the administrator to view the present setting or set the IPv4 address of
gateway and only accept “dotted decimal notation” format (e.g.: 192.168.1.254)
Primary DNS Server
This field allows the administrator to set the IPv4 address of the network DNS server and
only accept “dotted decimal notation” format (e.g.: 8.8.8.8).

Ingrasys iED N Series Specifications

General

Brand	Ingrasys
Model	iED N Series
Category	Controller
Language	English