INIM Electronics SmartLoop

Programming Manual
Initialising the configuration/programming from panel 23
Press keys  and  to navigate through
the loops.
7.4.4 Viewing I/O expansion boards
FROM PANEL
<any key>, 8 Programming, <code>, 1 Configuration, 1 View
configuration, 4 Optional cards, 
or <any key>, 8 <code> 1 1 4
7.5 Manual configuration
Manual enrolling from the control panel allows you to work on the configuration parameters of the
loops, Repeaters, I/O expansion boards and the telephone dialler board and on the parameters of the
loop devices.
7.5.1 Adding/Deleting Loops and data changes
FROM PANEL
<any key>, 8 Programming, <code>, 1 Configuration, 2 Modify
Configuration, 2 Manual Configuration, 1 Loop, 
or <any key>, 8 <code> 1 2 2 1
Press keys  and  to navigate
through the loops.
Press key  on the loop to be configured/
changed.
Press key
 on Loop Parameters to
access the loop configuration phase.
Note: For a full description of the parameters, refer to paragraph 17.1 Defining loop typology.
7.5.2 Add/Change device
FROM PANEL
<any key>, 8 Programming, <code>, 1 Configuration, 2 Modify
Configuration, 2 Manual Configuration, 1 Loop,
x Loop, 2 Add/Modify Point,

or <any key>, 8 <code> 1 2 2 1 x 2
Repeater n
in Configuration : YN
<Repeater Description>
I/O
in Configuration : YES
1 Loop 1 <Loop Description>
2 Loop 2 <Loop Description>
3 Loop 3 Not avaible
4 Loop 4 Not avaible

1 Loop Parameters
2 Add/Modify Point
3 Remove Point