Programming Manual
Initializing configuration/programming from a remote location 27
Chapter 9
Initializing configuration/programming from a remote location
Configuration/programming and maintenance operations can be done by the installer and authorized
technicians only (Level 3), who must have previously:
1. connected the programming jumper J2 PROGRAM;
2. set up the SmartLAN board for Internet access.
Then, after connecting to Internet can:
1. access the Internet browser and enter the IP address of the control panel;
2. enter the Access Code.
Note: Refer to Chapter 23 - Setting up the Internet network.
To Next Page
Loading...
Need help?
General
