Programming Manual
66 Maintenance operations
Chapter 27
Maintenance operations
The following maintenance operations can be implemented by installers or authorized technicians only
(Level 3) who can:
1. By means of a screw driver or similar tool, remove the screws and open the control panel cabinet.
2. Connect the programming jumper J2 PROGRAM.
3. Type in a valid access code: the control panel will allow access to the maintenance functions.
27.1 Testing/Enabling a zone
FROM COMPUTER
Not available.
During zone Test status, detectors and other signaling devices associated with the zone will be unable
to generate faults, alarms or signals. Activation of a detector during zone test status will light its LED,
which will reset automatically. This feature allows operators to test the system devices without moving
away from the panel.
FROM PANEL
<any key>, 7 Maintenance, <code>, 1 Zone in TEST Mode,
Press keys and to view the data of
the adjacent zones.
Press ESC to confirm the entry and step
back to the previous menu.
Note: Testing/Enabling a zone involves testing/enabling all the zone points (detectors).
27.2 Testing/Enabling a detector
FROM COMPUTER
Not available.
During test status, the detector will be unable to generate faults, alarms or signals. Activation of a
detector during test status will light its LED, which will reset automatically. This feature allows
operators to test the system devices without moving away from the panel.
FROM PANEL
<any key>, 7 Maintenance, <code>, 2 Point in TEST Mode, x Loop x,
yyy detector,
or
<any key>,
7 <code
> 2 x yyy
Press keys and to view the adjacent
detectors.
Press ESC to confirm the entry and step
back to the previous menu.
Zone yyy < Zone Description >
STATUS : _ormal Mode
= Select Zone = Test ON/OFF
Point x/yyy < Description >
Type : < Device Type >
STATUS : _ormal Mode
= Select Point = Test ON/OFF
To Next Page
Loading...
Need help?
General
