Programming Manual
30 The SmartLoop programming interface
Chapter 11
The SmartLoop programming interface
11.1 The SmartLeague software application user interface
When a SmartLeague solution opens, the following interface appears:
11.2 Configuring the system
1. From the Control panel section, drag the control panels and drop them to the network structure.
The system will add a control panel and standard components to the tree structure for each
control panel comprised in the network. Expand the system structure to verify:
Note: Consoles (keypads and displays) are not present on SmartLoop2080/S and SmartLoop1010/S
models.
2. From the configuration section, select the control panel you intend to configure.
[1] The open solution appears (other open solutions and the Start page will be put in the background).
[2] Tree-structure layout (represented by a network of control panels with on-board and optional
hardware modules). The system can be built by dragging the components from the System Layout
page and dropping them onto the respective section.
[3] The System Layout page (allows the installer to select the system components: type of control panel,
peripheral devices, modulesand drag and drop them onto the control panel structure).
[4] System Programming page (allows the installer to program the selected component).
1
2
3
4
To Next Page
Loading...
