Programming Manual
50 Programming the loops
Press keys and on the first line to
view the other loops.
Press keys and to scroll the
parameters list.
Press keys and on the other lines
to change the values.
Press
to save data and step back to the
previous menu.
Press ESC to quit without saving.
17.2 Add a ‘T’ junction to the loop
FROM COMPUTER
Go to SmartLoop System, Control panel x, Loop y, T Junction
In order to facilitate wiring operations, and allow the connection of devices that are isolated from the
loop, ‘T’ junctions can be used at splice points. When installing ‘T’ junctions, follow the respective
instructions in the Installation Manual paragraph 7.1 Note to the Installer regarding wiring and
connection compliancy.
FROM PANEL
Not available.
Loop Firmware release : 001
<Loop Description>
Loop Type: <Loop Type Description>
Loop Wiring : 4 Wires
To Next Page
Loading...
