Programming Manual
4
13.3 Defining Access Codes 39
13.4 Setting up holiday periods 40
Chapter 14 Programming the control panel............................................. 41
14.1 Setting the control panel parameters 41
14.2 Defining zones 41
14.3 Setting the Timers 43
14.4 Defining groups 44
Chapter 15 Programming from the console (Control panel and SmartLetUSee/
LCD Repeater frontplate)..................................................... 46
15.1 Monitoring notification 46
15.2 How to program the Customizable LEDs 46
15.3 Programming the 3 LEDs on SmartLetUSee/LCD Repeaters 47
Chapter 16 Power supply settings.......................................................... 48
16.1 How to program the power supply 48
Chapter 17 Programming the loops........................................................49
17.1 Defining loop typology 49
17.2 Add a âTâ junction to the loop 50
Chapter 18 Loop device settings............................................................ 51
18.1 How to program loop devices 51
Chapter 19 Programming the NAC outputs.............................................. 55
19.1 The intermittent signals of the NAC Outputs 55
19.2 The NAC outputs 55
Chapter 20 Programming the I/O expansion boards................................. 56
Chapter 21 Programming LED expansion boards...................................... 57
21.1 Programming the control panel expansion board LEDs 57
21.2 Programming SmartLetUSee/LCD expansion board LEDs 57
Chapter 22 Programming the telephone dialler........................................ 58
22.1 Setting up the Phonebook 58
22.2 Setting up the telephone actions 58
22.3 Setting up emergency calls 59
Chapter 23 Setting up the Internet network............................................60
23.1 Setting up the Internet connection parameters 60
Chapter 24 Programming the local network ............................................ 61
24.1 Programming the SmarLoop\NET board 61
Chapter 25 Setting up the events printout.............................................. 62
25.1 Programming the events printout on the thermal printer 62
25.2 Programming the events printout on the RSR232 port printer 62
Chapter 26 Closing the programming session..........................................65
Chapter 27 Maintenance operations.......................................................66
27.1 Testing/Enabling a zone 66
27.2 Testing/Enabling a detector 66
27.3 Forcing the output status of devices 67
27.4 Forcing the output status of the control panel 67
27.5 Forcing the device LEDs On 67
27.6 Testing the local network 68
27.7 Loop Diagnostics 68
Chapter 28 Operating the system.......................................................... 70
28.1 Change Day/Night mode 70
28.2 Bypassing a device 70
28.3 Bypassing a zone 70
28.4 Bypassing NAC outputs 71
Appendix A Installing the SmartLeague programming software.................. 72
A.1 Initial installion from the CD 72
A.2 Checking for the availability of SmartLeague software upgrades 72
To Next Page
Loading...
Need help?
General
